HIWIN HGW35HC Block-manufacture,factory,supplier from China

What is hot installation of machine tool bearings? How should we heat up the bearings of machine tools? Machine tool bearing hot installation generally refers to a heating process that involves installing the inner trap of the bearing onto the bearing block of the transmission shaft, and is divided into two processing processes: hot installation (or hot installation) and cold installation.

Dear users and partners:As 2024 slowly draws to a close, we welcome the hopeful year of 2025 with immense gratitude. At the beginning of this year, we express our sincerest gratitude and blessings to all the friends who have always supported us.The past year has been full of challenges and opportunities. We constantly innovate in the process of change and forge ahead with persistence. Whether it's technological innovation, service optimization, or the joint efforts of the team, they all rely on your unwavering support and trust.

When replacing peripheral parts of the device, carry out regular maintenance, operational checks and inspections of the removed bearings to determine whether they can be reused and whether they are in good or bad condition.First, carefully examine and note the removed bearings and their appearance. To clarify and check the amount of residual grease, the bearings must be thoroughly cleaned&nbs

Annealing, also known as simmering, code name Th, is the process of heating a steel piece to Ac1 or Ac3 or above (30-50 ℃), holding it for a period of time, and then slowly cooling it (usually using furnace cooling).Normalization, also known as open flame, code Z, is the process of heating steel parts to Ac3 or Acm or above (30-50 ℃), holding them for a period of time, and then cooling them in air at a slightly faster cooling rate than annealing.The main difference between bearing annealing and normalizing is that normalizing is a deformation or special case of complete annealing, and the only

On the occasion of the opening of the 2023 Asia International Power Transmission and Control Technology Exhibition, on behalf of the company, I would like toextend a warm welcome to customers and friends from all over the world! Warm congratulations on the convening of the 2023 Asia International Power  Transmission and Control Technology Exhibition (PTC ASIA)!This year's PTC exhibition is particularly focused on the new ecosystem of intelligent manufacturing.

Bearings are crucial components for maintaining the normal operation of the vibrating screen. During normal operation, bearings should run smoothly and without any noise. However, due to poor quality or improper operation of the vibrating screen, bearings are prone to overheating, causing wear and even fracture, which seriously affects the normal use of the vibrating screen.1.Insufficient lubricationDuring the use of bearings, the internal lubricating oil is gradually consumed.

1、 What is bearing chamfer?Chamfer is a term used in mechanical engineering. In order to remove burrs caused by machining on parts and to facilitate assembly, chamfers are generally made at the ends of parts. Chamfering can be seen everywhere in our daily lives, on the borders of mobile phones, on tempered doors, on vases, and so on.The general purpose of chamfering is to remove burrs and make it aesthetically pleasing.

As the number one and world-renowned agricultural machinery exhibition in Asia, the International Agricultural Machinery Exhibition has always attracted exhibitors from all over the world. This year, there were three more foreign exhibition groups, including Italian, German, Canadian, Türkiye, Japan, Algeria, South Korea and other enterprises. In addition, there has been an increase in overseas audiences from major agricultural producing countries around the world, such as Southeast Asia and Central Asia, with over 2000 registered viewers.

SFC bearings are a Chinese brand. Since 2003, SFC bearings have played an active and important role in the aerospace, automotive and industrial fields, covering applications in production machinery, power transmission and railways, heavy industry and consumer goods industries.

From September 30 to October 5, 2024, Türkiye Machine Tool Exhibition will be held in Istanbul as scheduled. During the exhibition, we received business cards from customers from Türkiye, Iran, Russia and many other countries, felt the enthusiasm of visitors and recognition of our products, and looked forward to cooperating with them.